Features
For mounting heights to 14′ (environmental separation) and 12′ (insect control).
The Berner Industrial Corro-Duty 14 Air Curtain is durable with all-welded construction of stainless steel.
Used to save energy and keep temperatures stable and flying insects out when the doors are open.
- Specifically built for Corro-Duty applications
- Engineered to perform and built to last
- Simple to install, operate, and maintain
- Made in U.S.A.
Berner is a UL Listed panel shop, authorized to build UL listed Motor Control Panels.
Available in single lengths from 3′ to 16′
Corro-Duty Details
Applications:
For industry applications requiring protection against corrosion caused by severe environmental operating conditions including petro-chemical plants, mines, foundries, pulp and paper plants, waste management facilities, chemical plants, and tropical climates.
Unit Features:
Cabinet and internal components including fans are stainless steel. Industrial units already use waterproof wiring compartments.
Motor Features:
Single speed, corrosion resistant epoxy finish, sealed pre lubricated bearings, oversized rotatable cast iron conduit box, cast iron frames, Neoprene V-ring sling, heavy duty cast iron construction, enhanced ingress protection, moisture resistant copper windings, Class F insulation, tropicalized, stainless steel nameplate and corrosion resistant hardware.
Accessories
This model requires a separate Activation Switch. All air curtains using control panels require an Activation Switch to be ordered with the panel.
Control Panels
Standard location: Factory installed on left hand end plate of air curtain.
Single Phase Control Panels:
A single phase control panel is required when:
- A time delay is used
- 24 volt control is used
- When motor quantities exceed: (2) 1/2 hp @ 120V or (3) 1/2 hp @ 208-240V
An activation switch must be selected along with the panel for activation of the air curtain.
Standard control panel construction: NEMA 4/12 Enclosure, Motor Contactor (factory wired), Terminal Strip, Fusing (as required), Time Delay (as required).
Three Phase Control Panels:
All three phase power supplies require a three phase control panel and an activation switch.
Standard Control Panel Construction: NEMA 4/12 Enclosure, Motor Contactor (factory wired), Terminal Strip, Fusing (as required), and Time Delay or 120V Control Transformer (as required).
