Key Features 

• Durable, all-welded stainless-steel construction. 
• Specifically built for Corro-Duty applications. 
• Helps save energy, keep temperatures stable, and keep flying insects out when doors are open. 
• Engineered to perform and built to last. 
• Simple to install, operate, and maintain. 
• Made in the U.S.A. 
• Berner is a UL Listed panel shop, authorized to build UL listed Motor Control Panels. 

Specs & Mounting 

• Mounting heights: up to 16 ft. for environmental separation and 14 ft. for insect control. 
• Available in single lengths from 5 ft. to 16 ft. 

Applications:

For industry applications requiring protection against corrosion caused by severe environmental operating conditions including petro-chemical plants, mines, foundries, pulp and paper plants, waste management facilities, chemical plants, and tropical climates.

Unit Features: 

Cabinet and internal components including fans and blower shafts are stainless steel. Industrial units already use waterproof wiring compartments.  

Motor Features:

Single speed, corrosion resistant epoxy finish, sealed pre lubricated bearings, oversized rotatable cast iron conduit box, cast iron frames, Neoprene V-ring sling, heavy duty cast iron construction, enhanced ingress protection, moisture resistant copper windings, Class F insulation, tropicalized, stainless steel nameplate and corrosion resistant hardware.

Control Panels

Standard location: Factory installed on left hand end plate of air curtain.

Three Phase Control Panels:

All three phase power supplies require a three phase control panel and an activation switch.

Standard Control Panel Construction: NEMA 4/12 Enclosure, Motor Contactor (factory wired), Terminal Strip, Fusing (as required), and Time Delay or 120V Control Transformer (as required).